Support de MevoPlus (avec poignées en plastique)
TESTÉ PAR FLIGHTSCOPE
SUPPORTE le launch monitor Mevo+ de Flightscope.
PROTÈGE le Mevo+ des retours possibles de balles sur un simulateur muni d’une toile d’impact.
AJUSTE l'appareil aux degrés demandés par les différentes applications.
- Trois tiges d'ajustement pouvant aller jusqu'à 2-1/2 po de haut ;
- Plexiglass avec arêtes sablées et coins arrondis faciles à retirer ;
- Trois positions déjà réglées (18-12-10 degrés) ;
- Possibilité de fixer le Mevo+ sur le support pour le transport.
My initial feedback was incorrect as it was pointed out I needed to remove the protective film from the plexiglass/ Oops on my pat Sylvain reached out promptly and pointed that fact out / All good device works as intended
My first issue is that I have noticed an increase in missed shots, I don't know for sure but it definitely started happening when I put the Mevo in the unit. Second, none of the slots in the unit do not correspond to the 12 degrees used for simulation use, so I have to do that manually with the screws - which means that the Mevo is not actually sitting flat on the ground. I paid an extra few bucks for express shipping, only to be told that there was a delay in production so I'd have to wait a couple weeks past when the Etsy site said I'd get the product. I knew I was taking a bit of a risk when I purchased it, and I suppose it's still nice to have some protection in front. My biggest issue by far is that I have used it twice, and both times, the number of missed shots increased substantially even though the placement and angle were identical to my normal setup.